• 中文版本

WeActStudio.PDPowerMiniV1-Buck

Specification
Input	DC 24V/PD 20V/QC 12V,3A
Output	1-20V/0.05-3A + 5V/0.3A
Output Setting Accuracy	±0.01V/±2mA
Output Display Accuracy	±0.02V/±3mA
Main Output Voltage Ripple	<±25mV
Output Protection	Overcurrent Protection,Short-circuit Protection

Note: The main output current of 2A can operate for a long time, while 3A current requires enhanced heat dissipation

Product Introduction

Setting Introduction

1. Brightness – Brightness: Adjustable from 0–100%; 0–10% corresponds to ultra-low brightness.
2. Reverse Dis – Reverse Display: 0 = Normal, 1 = 180° rotation. Setting takes effect after power cycle.
3. OCP Enable – Over-Current Protection: 0 = Disabled, 1 = Enabled. Output shuts down after approximately 200 ms when current exceeds the set value.
4. OC Discharge – Over-Current Discharge: 0 = Disabled, 1 = Enabled.
5. AUTO OUT – Auto Output: 0 = Disabled, 1 = Enabled. Output automatically enables after power-on.
6. Filter.Win – Output Filter Window: Adjustable from 1–200, default value 50.
7. Factory Reset – Factory Reset: Set to 1 and exit the settings menu to restore factory defaults (calibration values will not be cleared).
8. Offset Enable – Calibration Enable: 0 = Disabled, 1 = Enabled. Factory default is 1 (calibrated).

Test Data

Computer Software Introduction

/*---------------------------------------
- WeAct Studio Official Link
- taobao: weactstudio.taobao.com
- aliexpress: weactstudio.aliexpress.com
- github: github.com/WeActStudio
- gitee: gitee.com/WeAct-TC
- blog: www.weact-tc.cn
---------------------------------------*/