[DETECTION]: platformio.ini file update for pins 12 / 13 - no signal (esp32 S3)

[adamau5]

Detection Issue Type

False Detection (detecting jam when none exists)

Problem Description

hi, i have udpated the ini file, but no signal detected, any ideas? I see another user on reddit is the same.

Steps to Reproduce

power on, wire as per here: https://github.com/jrowny/cc_sfs, edit ini (as generic boards dont have a pin 27)

ESP32 Board

esp32-s3

Firmware Version

No response

Relevant Configuration

Logs

Expected Behavior

No response

Actual Behavior

No response

Additional Context

No response

[adamau5]

just for clarity - I built the OTA files and used the updated ini file. then OTA'd.

i get the same results as this https://www.reddit.com/r/ElegooCentauriCarbon/comments/1r4yhw5/openfilamentsensor_by_harpua555_help/

[adamau5]

Sorted. Move to another pin, all sorted will give it a good test. Cheers.

[adamau5]

I had another issue of from a cold boot, my aliexpress s3 would boot properly (a quick on an off worked fine). I inserted a delay in the main.ccp.
under the void setup bit - right at the start
void setup()

{

delay(2000); // Give the power supply 2 seconds to stabilize

[harpua555]

#105 resolves documentation mistake when adding ESP32-WROOM (README combined this with S3 which was incorrect)
v0.8.7 has correct instructions and build

[adamau5]

#105 resolves documentation mistake when adding ESP32-WROOM (README combined this with S3 which was incorrect) v0.8.7 has correct instructions and build

Thanks. I just tested your update (and moved to pinout suggested). All good. Thank you for the project.

PS - Anyone reading this using an aliexpress s3, a 10uf cap from rst to ground sorted my cold boot issues.