getting this error randomly in the middle of prints. last print was 5 hours long and failed at the 4 hour mark. has also happened on occasion directly after pressing home or start print (thinking that's unrelated). release v0.0.7. using adaptive pressure advance in orcaslicer, and ive only had it happen since enabling this. (but i also only put a few hours on it without)
have tried: disabling webcam (disabling ustreamer) to free up cpu.
its hard for me to get data because i can start the same gcode file again after rebooting and itll be fine
MCU 'mcu' shutdown: Timer too close
This often indicates the host computer is overloaded. Check
for other processes consuming excessive CPU time, high swap
usage, disk errors, overheating, unstable voltage, or
similar system problems on the host computer.
Once the underlying issue is corrected, use the
"FIRMWARE_RESTART" command to reset the firmware, reload the
config, and restart the host software.
Printer is shutdown****
EDIT: realized i never actually checked if full motherboard fan speed fixes it or not
getting this error randomly in the middle of prints. last print was 5 hours long and failed at the 4 hour mark. has also happened on occasion directly after pressing home or start print (thinking that's unrelated). release v0.0.7. using adaptive pressure advance in orcaslicer, and ive only had it happen since enabling this. (but i also only put a few hours on it without)
have tried: disabling webcam (disabling ustreamer) to free up cpu.
its hard for me to get data because i can start the same gcode file again after rebooting and itll be fine
EDIT: realized i never actually checked if full motherboard fan speed fixes it or not