Add a G-Code for pause until user un-pauses

[wcraigtrader]

There ought to be a way to modify G4 or add another G-Code that acts the same way as pressing the pause button in the controller. Then you could put that G-Code into your file, and when the Carvera gets to that spot in your job, it pauses, just like if you hit pause in the Controller. This allows the user to do any manual steps (eg: vacuuming, adding cutting oil, whatever), then go to the Controller and hit pause again, to un-pause the job.

[ACaesuraIsStillMusic]

M600 works for this

[AlbertEE00]

Thank You, was searching for this!