Bugfix Rewards Program Submission

[ayyaz20003]

Hello,

I would like to submit a request under the Bugfix Rewards Program for 5 confirmed bug fixes.

All five issues below were labeled Status: Confirmed and Type: Bug at the time the corresponding pull requests were submitted and merged, and none of the issues were reported by me. All five PRs were merged within a 12-week window (2026-04-04 to 2026-06-22, 79 days).

For full transparency: these issues were not on the FPA Reward Program Eligible Issues board and did not carry the newer Reward Eligible label. The fixes were undertaken in good faith under the original program terms — find a confirmed bug and submit a PR that resolves it — and the issues were opened before (or straddle) the rollout of the newer eligibility label. I'm raising this openly so it can be considered; happy to discuss if any adjustment is needed.

Qualifying PRs (newest to oldest)

• PR: TechDraw: keep DraftView/ArchView ScaleType "Page" across save and reload FreeCAD#30529 — Issue: TechDraw: DraftView and ArchView 'Scale' setting is reset during save-open cycle FreeCAD#30186 (Type: Bug, Status: Confirmed; reported by semhustej; merged 2026-06-22)
• PR: TechDraw: prevent edge deletion on torus and similar concentric-arc shapes FreeCAD#29637 — Issue: TechDraw: incorrectly shows shape (issue in duplicate edge removal process ("scrubbing")) FreeCAD#18991 (Type: Bug, Status: Confirmed; reported by kazan417; merged 2026-05-14)
• PR: TechDraw: fix ArchView incorrect B-spline representation (#27802) FreeCAD#28853 — Issue: BIM: TechDraw_ArchView incorrect representation of an object FreeCAD#27802 (Type: Bug, Status: Confirmed; reported by semhustej; merged 2026-04-22)
• PR: TechDraw: Fix DraftView and ArchView not respecting page Scale on cre… FreeCAD#28818 — Issue: TechDraw: DraftView and ArchView don't respect page Scale property on creation FreeCAD#27698 (Type: Bug, Status: Confirmed; reported by semhustej; merged 2026-04-22)
• PR: Gui: Fix Sketcher toolbar state not persisting across workbench switches FreeCAD#28674 — Issue: Sketcher: toolbars break when following a specific sequence of steps FreeCAD#28602 (Type: Bug, Status: Confirmed; reported by entuland; merged 2026-04-04)

Please let me know if any additional information is required.

Best regards,
Ayyaz (ayyaz20003)

[chennes]

FYI there will be a delay in the evaluation of this submission: the last funding allocation for the program has been spent and the FPA has to determine whether to add more money to the rewards program pool. It is on the agenda for this week.